U-Line CLR2160 Specifications download pdf (Page 21)

CLR2160, CLRCO2175 21

4. Check that the clamps and hose connections are tight at

the following areas (see

Figure 36

• Discharge tube (A)

• Drain tube (B)

• Vent tube (C)

Figure 36

5. Place a suitable container beneath the pump’s discharge

tube. (The bucket must be able to hold a minimum of

one gallon.)

6. Plug the ice maker power cord into a properly

grounded, polarized electrical outlet.

7. Place the unit into OFF mode by holding power key for

10 seconds. Not doing this will cause the unit to start

the fill cycle which will run for 3 minutes.

8. Verify pump operation by pouring one gallon of water

into the ice storage bin of the ice maker. The pump

should energize and pump the water into the container.

9. At this time, verify that all tube and clamp connections

are tight and leak-free.

10. Unplug unit power cord from electrical outlet.

11. Reinstall back panel.

Locally-Installed Drain Pump

If a gravity drain connection is not possible, and you have

not purchased a CLR2160 or CLRCO2175 with factory-

installed pump, we strongly recommend the use of the

U-Line P60 drain pump. The U-Line P60 drain pump is

available through your Dealer, with complete installation

instructions. If a pump other than the U-Line P60 drain

pump is to be used, it must meet the following

specifications:

•

It must be UL listed and have a UL listed, 120 VAC,

3-wire grounded power cord.

•

It must have overall maximum outside dimensions of

8-3/4" wide x 5-3/4" deep x 7-3/4" high.

• It must have a minimum flow rate of 1.5 gallons per

minute at 10 feet of lift.

• It must have a sealed sump which does not allow water

leakage in the case of a power outage, restricted drain

or pump failure.

• It must have a check valve in the discharge line to

prevent waste water return to the pump.

• It must have an overflow protection control which will

shut off power to the ice maker in the event of a pump

failure.

• It must have an operating temperature range of 50°F

to 110°F (10°C to 40°C).

IMPORTANTIMPORTANT

In the event of a power outage, restricted drain or

pump failure, the failure to use the U-Line P60 drain

pump or a pump with the above listed

specifications, could result in substantial water

leakage and pooling with severe and costly water

damage and related consequential damages and

harm.

Figure 37

Figure 38

Back View Side View

ULIN_0575_A

Cold

Water

Hot

Water

Waste

Shut-Off

Valve

Stand Pipe

P60 Pump Required

ULIN_0571a_A

Air Gap

(Optional Hook-Up)

Cold

Water

Hot

Water

Waste

Shut-Off

Valve

Disposal Assembly

P60 Pump Required

ULIN_0572a_A

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

Comments to this Manuals

No comments

U-Line CLR2160 Specifications Page 21

Comments to this Manuals

Related products and manuals for Unknown U-Line CLR2160