U-Line CLR2160 Specifications download pdf (Page 18)

18 CLR2160, CLRCO2175

To install the door shelf:

1. Holding shelf in center, align notches (Figure 28, 1) in

shelf with bosses (Figure 28, 2) in door.

2. Tilt shelf at a 15°-20° angle and slide onto bosses at the

desired location.

Glass Shelf Removal/Installation

Figure 29

1. Pull shelf out about 6" (Figure 29, 1) until back of

shelf clears the "hump" on the right-hand side.

2. Tilt right-hand edge of shelf up.

3. Remove shelf from unit by pulling out

(Figure 29, 2)

Insert the shelves as follows:

1. To move to a different position in the unit, insert shelf

at an angle, approximately 15-20°, over the rib in the

side of the unit where you want to place the shelf. The

shelf must be started into the unit at an angle to clear

the door.

2. Continue to slide the shelf into the unit at an angle

until it clears the door.

3. Lower the shelf and push it in completely.

CAUTION

Plumbing installation must observe all state and

local codes. All water and drain connections MUST

BE made by a licensed/qualified plumbing

contractor. Failure to follow recommendations and

instructions may result in damage and/or harm.

Water Supply Connection

When connecting the water supply, follow these

guidelines:

• Review the local plumbing codes before you install the

unit.

• Connect to the cold water supply.

• The water pressure should be between 20 and 120 psi.

• The water line MUST have a shut-off valve in the 1/4”

O.D. supply line.

• Leave approximately 8’ of water line to be coiled

behind the appliance (see Figure 30). The water line

should be looped into 2 coils. This will allow the unit to

be removed for cleaning and servicing. However, make

certain that the tubing is not pinched or damaged

during installation.

NOTE: U-Line requires the use of copper tubing

for installation. Do not use any plastic water supply

line because the line is under pressure at all times.

Plastic may crack or rupture with age and cause water

damage to your home.

To connect to water supply:

1. Locate the desired cold water supply location. Attach a

1/4” copper line to this location and route the tubing

to the appliance. Leave approximately 8’ of water line

to be coiled behind the appliance. The water line

should be looped into 2 coils. This will allow the line to

flex when removing the unit for cleaning and servicing

(see Figure 30).

ULIN_0276_A

7 Prepare Plumbing

ULIN_30096_5-7-07.fm Page 18 Friday, May 11, 2007 11:06 AM

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Comments to this Manuals

No comments

U-Line CLR2160 Specifications Page 18

Comments to this Manuals

Related products and manuals for Unknown U-Line CLR2160