U-Line 29R Installation Guide download pdf (Page 9)

02/2005 9 www.U-LineService.com

29R Refrigerator

Installation of the 29R

Plug in the power cord.

2. Gently push the unit into position. Be careful not to

entangle the electrical cord.

3. Re-check the leveling, from front to back and side to

side. Make any necessary adjustments. The unit’s top

surface should be approximately 1/8" below the

countertop or filler panel.

Grille Installation

1. Locate and remove the grille screw from the cabinet,

using a standard blade screwdriver (or a 1/4"

nutdriver). See Figure 18

2. Remove the control knob by pulling it away from the

cabinet.

3. Identify the grille screw hole on the grille itself. It is

located toward the top of the middle recessed section

of the grille.

4. Place the two hook-hinges (located on the rear bottom

side of the grille) onto the front lip of the unit base.

Swing the grille up into position, aligning the grille

screw hole on the grille to the grille screw hole on the

cabinet. See

Figure 19

5. Insert the screw. Do not overtighten.

6. Reinstall control knob.

Glass Shelf Installation

1. Carefully remove the glass shelves from the packaging.

2. Slide the shelves onto lower sets of ribs, making sure

the decorative graphics are on the underside of the

shelves. While edge strips go toward the rear and silver

edge strips go toward the front. See

Figure 20

8 Install the Unit

Grille Screw

Figure 18

Hook-Hinge

Unit Base

Front Lip

Grille

Figure 19

Figure 20

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments

U-Line 29R Installation Guide Page 9

Comments to this Manuals

Related products and manuals for Unknown U-Line 29R