U-line 2175WCC User Manual download pdf (Page 19)

Level & Install Unit 17

12 Installation

Leveling Information

It is recommended that the unit is level.

1. Use a level to check

the levelness of the

unit from front to

back and from side

to side. Level should

be placed along top

edge and side edge

as shown

2. If the unit is not level, adjust the feet on the corners of the unit

as necessary (not available in CO29 models).

3. Check the levelness after each adjustment and repeat the

previous steps until the unit is level.

INSTALLATION TIP

If the room floor is higher than the floor in the cut-out opening,

adjust the rear feet to achieve a total unit rear height of 1/8" less

than the opening’s rear height. Shorten the unit height in the front

by adjusting the front feet. This allows the unit to be gently tipped

into the opening. Readjust the front feet to level the unit after it is

correctly positioned in the opening.

Turn Foot to Adjust

Installation

1. Plug in the powercord.

2. Gently push the unit into position. Be careful not to kink the

water supply line or entangle the electrical cord.

3. Re-check the leveling, from front to back and side to side. Make

any necessary adjustments. The unit’s top surface should be

approximately 1/8" below the countertop.

4. Remove the tape from the glass shelves and wipe out the inside

of the unit with a clean, water-dampened cloth.

Relocating the Shelves

Both the glass shelves in the refrigerator and the inner door

shelves can be moved to accommodate your bottles, cans and

containers.

Glass Shelves on Right-Hand Hinge Units

• Open door fully, grasp shelf firmly, lift front edge slightly, and

pull straight out.

• Choose new location and slide shelf onto the appropriate rib.

Glass Shelves on Left-Hand Hinge Units

• Pull shelf out about 6” to clear the wall’s molded protrusion.

• Tilt right-hand edge of shelf up.

• Keeping at this angle and hugging the right wall, pull the shelf

out.

• Choose new location and insert over ribs, tilting right-hand

edge up. Push in, then lower shelf onto ribs.

Door Shelves

• First pull shelf up at a 45° angle, then straight out (see Figure

39).

• Choose new location and line up on bosses. First push straight

in, then down at a 45° angle.

Installation Troubleshooting

Problem

The door remains open unless it is pushed closed.

Solution

The hinges should be self-closing when the door is open

approximately 8". If this is not the case, make sure the closers are

clean, greased and installed correctly. Also, re-check leveling from

front to back of the unit and readjust if necessary. Make sure that

pivot plate is installed correctly.

Problem

The custom overlay door was designed to align with the rest of the

cabinet doors, but the unit has crept forward.

Solution

Make sure that the electrical cord and water supply line are not

obstructing the installation.

1 2 ... 14 15 16 17 18 19 20

Comments to this Manuals

No comments

U-line 2175WCC User Manual Page 19

Comments to this Manuals

Related products and manuals for Refrigerators U-line 2175WCC