U-Line CO2175FF Installation Guide download pdf (Page 16)

www.U-LineService.com 16 08/2006

CO2175FF — Combo® Ice Maker/Refrigerator

Initial Start-Up

Once installation and leveling is complete, the unit is

ready for initial start-up and operation. The POWER icon

is located inside the unit.(see Figure 40,1).

1. The unit should already

be plugged into the

electrical outlet. Make

sure the water supply is

turned on.

2. Open the door and press

the

POWER

icon on the

display to turn the unit on

(see Figure 40,1).

3. As soon as the ice maker

mold reaches the proper

temperature, the ice

maker mechanism will fill the mold with water.

Note: The first cubes may be small because of air in the

water line. After two hours, cubes will be standard size.

4. The ice maker will continue to produce until the bin is

full. You may interrupt production by raising the bin

arm into an upright and locked position (see

Figure

). While the bin arm is locked, the unit will maintain

temperature for ice storage.

IMPORTANT

It is possible that dirt or scale will dislodge in the water

line. Always throw away all ice cubes made during the

first twenty-four (24) hours of operation.

CAUTION

• The ice bucket MUST be fully inserted to avoid freezing

products in the refrigerator section. The ice bin door

must be fully closed with the door lip inside the ice

bucket.

• Do not place cans or bottles so they are touching the

back wall of the refrigerator section, as they may

freeze.

• Do not place any objects over air inlet or outlet in the

freezer section.

About Settings

No adjustments should be necessary at this time. For

information about Adjusting the Temperature Control

and Adjusting the Cube Size, see the Use and Care Guide.

Start-Up Troubleshooting

Problem

Unit does not appear to turn on when POWER icon is

pressed.

Solution

Make sure unit is plugged in and outlet has power (circuit

breaker has not tripped). Remember that the ice maker

mechanism will not fill the mold with water until the

mold reaches the proper temperature.

Problem

Water does not appear to be flowing into unit.

Solution

Check that the water is connected and turned on and the

line is not obstructed.

Problem

The cubes produced during the first two to three hours of

operation have been discarded. New cubes still appear

cloudy.

Solution

This is normal and is caused by air being trapped in the

cube during fast freezing.

IMPORTANT

See the Use and Care Guide’s Troubleshooting Guide for

Comments to this Manuals

No comments

U-Line CO2175FF Installation Guide Page 16

Comments to this Manuals

Related products and manuals for Fridges U-Line CO2175FF