U-Line CO2175FF Installation Guide download pdf (Page 10)

www.U-LineService.com 10 08/2006

CO2175FF — Combo® Ice Maker/Refrigerator

Attach the door panel to the overlay panel using #10 x 5/

8" wood screws and nylon spacers. The nylon spacers fit

between the overlay panel and the door panel as shown

in Figure 21. The spacers

allow the original door panel

to slide back into the

1/4"-thick door reveal (channel).

3. Remove the existing bottom pivot plate and replace

with the Full Overlay pivot plate (see

Figure 22

IMPORTANT

Door panel and overlay panel must be aligned properly or

the door will not operate correctly.

Assembling the Door

1. Install the assembled panel by sliding the original door

panel back into the doorframe.

2. Replace the Overlay Handle and secure with the two

screws removed in Step 4 under Removing Existing

Door.

3. Attach Overlay cap to door, opposite side of where

hinges will be (see

Figure 23

4. Attach Top Pivot Plate to door handle, on side where

hinges will be. Use the two #8-32 x 1/2" Flat Head

Phillips screws (Black) supplied with kit (see

Figure 24

5. Starting at the corners and working toward the center,

push the door gasket back into place.

Installing the Door

1. Remove the existing hinges from the unit, saving the

door closure assembly.

2. Install the new Replacement Top Hinge onto the unit

(see

Figure 25

28-7/8"

1/4"

15-9/16"

1/4"

2-5/8"

1/4"

Drill ø 5/32" x 3/8" Deep

7 Places Model 2175

6 places Model 2115 and CLR2160

For use with #10 x 5/8"

Wood Screw and Nylon Spacer

11-7/8±1/32

For use on

Model 2175 Only

ULIN_0402_A

Figure 20

#10 x 5/8"

Round Head Screw

Seven Required

Typical

Wood Panel

Door Panel

Plastic Spacer

Seven Required

Figure 21

#8-32

3/8" SEMS Hex Screw

Two Places

Wood Panel Bottom Pivot Plate

(5/8" Longer Than

Existing Bottom Pivot Plate,

Flush Side Facing Out)

Existing

Door

Existing Bottom Pivot Plate

(Remove and Discard)

Figure 22

3/4" Wood Panel

Overlay Cap

Replacement Handle

Figure 23

3/4" Wood Overlay

#8-32 x 1/2" Flat Head Screws

Black, Two Places

Top Pivot Plate

Screw to attach Handle

Removed in step 4

Figure 24

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17

Comments to this Manuals

No comments

U-Line CO2175FF Installation Guide Page 10

Comments to this Manuals

Related products and manuals for Fridges U-Line CO2175FF