U-Line 2275DWRCOL Troubleshooting Guide Page 14

  • Download
  • Add to my manuals
  • Print
  • Page
    / 24
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 13
u-line.com 11
Light Bulb Replacement
To replace the light bulb in your U-Line unit:
1. Find the light located at the top of the unit. Grasp the edges of
the light housing lens (1) opposite the exposed tab and gently
push the lens toward the tab (2).
2. Pull the edge of the lens down (1) and swing it out of the light
housing.
NOTICE
ALWAYS use a genuine U-Line replacement 120V 10 watt
bulb (Part Number 31317) in the light housing. Use of any
other bulb within the housing will produce excessive heat,
causing damage to the light housing and cabinet interior,
and will compromise the precise temperature control of
the unit.
1. Replace the lens by first inserting the tab side back into the
housing at a slight angle.
2. While gently pushing the lens towards the tab end, push the free
end into the housing, and release when you hear a snap.
Leveling
NOTICE
Unit must be level, for proper door and ice maker (if
equipped) operation.
For Models with adjustable leveling feet:
1. Use a level to check the levelness of the unit from front to back
and from side to side. Place the level along top edge and side
edge as shown (1).
2. If the unit is not level, rotate the adjustable leveling legs to raise
or lower each corner of the unit (5) as necessary.
3. Check levelness after each adjustment and repeat the previous
steps until the unit is level.
Removing and Installing Grille
WARNING
!
Disconnect electric power to the unit before removing
the grille.
WARNING
!
DO NOT touch the condenser fins (4). The condenser
fins are SHARP and can be easily damaged.
Removing the grille.
1. Disconnect power to the unit.
2. Loosen the two screws (1).
3. Remove grille (2) and grille cap (if equipped) (3) from unit.
Installing the grille:
1. Place the hook-hinge located on the rear bottom side of the
grille (2) onto the front lip of the unit base. Swing the grille up
into position.
2. Align cabinet and grill holes and secure, but do not overtighten
grille screws (1).
3. Reconnect power to the unit.
Typical Model Shown
Maintenance
2
1
4
1
2
5
Page view 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Comments to this Manuals

No comments