Use and Care GuideBI98BI95SP18Ice Maker Models:BI95, BI98, SP18ULIN_016357_30098.fm Page 1 Tuesday, March 14, 2006 2:32 PM
10 BI95, BI98, SP18MaintenanceProper maintenance of your U-Line product will ensure efficiency, top performance and long life. The maintenance interva
BI95, BI98, SP18 116. Insert the grille screw (Figure 8, 1) and tighten. Do not over-tighten. 7. Reconnect power to the unit.Ice Maker MaintenanceInle
12 BI95, BI98, SP18Ice Cube Thickness AdjustmentInterval - As RequiredThe ice cube size may be adjusted by changing the amount of water injected into
BI95, BI98, SP18 13Door Alignment Check and AdjustmentIMPORTANTIMPORTANTProperly aligned, the door’s gasket should be firmly in contact with the cabin
14 BI95, BI98, SP185. Remove screws on opposite side of cabinet (Figure 19). Note that there may be a nut behind one or both screws on either side.Fig
BI95, BI98, SP18 15Before Calling for ServiceIf your U-Line product appears to be malfunctioning, read through the OPERATION section of this guide to
16 BI95, BI98, SP18Troubleshooting GuideDANGERELECTROCUTION HAZARDNever attempt to repair or perform maintenance on the unit until the main electrical
BI95, BI98, SP18 17This page intentionally left blank
18 BI95, BI98, SP18This page intentionally left blank
BI95, BI98, SP18 19U-Line Corporation Limited WarrantyU-Line Corporation warrants each U-Line product to be free from defects in materials and workman
2 BI95, BI98, SP18Congratulations on your purchase of a U-Line refrigeration product. A pioneer in the field for more than 40 years, U-Line Corporatio
For General Inquiries:P.O. Box 245040Milwaukee, Wisconsin 53224-9540 U.S.A.Phone (800) 779-2547 FAX (414) 354-5696www.U-Line.comFor Service and Parts
BI95, BI98, SP18 3Introduction ...
4 BI95, BI98, SP18This page intentionally left blank
BI95, BI98, SP18 5IMPORTANTIMPORTANTPLEASE READ all instructions completely before attempting to install, operate, or service your unit.• Proper insta
6 BI95, BI98, SP18Origins Ice MakerModels BI95, BI98, SP18All Origins Ice Makers provide high daily ice production and storage capabilities, and conse
BI95, BI98, SP18 7Model SP18To turn the unit on or off, press the rocker switch (Figure 3) located in the center of the lower grille. Ice Harvest Cont
8 BI95, BI98, SP18Normal Operating SoundsAll models incorporate rigid foam insulated cabinets to provide high thermal efficiency and maximum sound red
BI95, BI98, SP18 9Product DisposalIf the unit is being removed from service for disposal, check and obey all Federal, State and/or Local regulations r
Comments to this Manuals