U-Line H-1027 Specifications

0513 IH-1027PAGE 1 OF 11Before operating this stapler familiarize yourself with the safety warnings and instructions in this manual. Keep these instru

0513 IH-1027PAGE 10 OF 11VALVE AND TUBE O-RING REPLACEMENT1. Loosen screws with a flat screwdriver. (See Figure 27)2. Remove spring with needle nose

0513 IH-1027PAGE 11 OF 11PISTON REPLACEMENT1. Remove screws and nut with 8 mm spanner wrench and 4 mm Allen wrench. (See Figure 31)2. Remove magazin

0513 IH-1027PAGE 2 OF 11SAFETY INSTRUCTIONSGENERAL SAFETY1. Read the manual and understand all safety instructions before operating the stapler. If y

0513 IH-1027PAGE 3 OF 11SAFETY INSTRUCTIONS CONTINUEDLOADING THE STAPLER1. Disconnect the air supply.2. Pull the pusher back until it stops on pushe

0513 IH-1027PAGE 4 OF 11SAFETY INSTRUCTIONS CONTINUEDCLINCH ADJUSTMENTUse 2.5 mm Allen wrench and turn collar through window clockwise to tighten clin

0513 IH-1027PAGE 5 OF 11OPERATING INSTRUCTIONS1. Protect your eyes and ears. a. Wear safety glasses with side shieldsb. Wear hearing protection.c

0513 IH-1027PAGE 6 OF 11OPERATING INSTRUCTIONS CONTINUEDCLEARING A JAM1. Disconnect air supply.2. Pull pusher back and rotate to a locked position.

0513 IH-1027PAGE 7 OF 11OPERATING INSTRUCTIONS CONTINUEDTEETH REPLACEMENT1. Loosen screws and nut with an 8 mm wrench and 4 mm Allen wrench. (See Fig

0513 IH-1027PAGE 8 OF 11DRIVER REPLACEMENT1. Disconnect the air supply.2. Loosen screw and nut with a 8 mm spanner wrench and a 4 mm Allen wrench. (

0513 IH-1027PAGE 9 OF 11PUSHER SPRING REPLACEMENT1. Loosen the screws and nut with a 8 mm spanner wrench and a 4 mm Allen wrench. (See Figure 21)2.