U-Line U-3018CLRS-01 Troubleshooting Guide download pdf (Page 11)

8 u-line.com

Leveling

NOTICE

Unit must be level for proper door and unit operation.

1. Use a level to check the levelness of the unit from front to back

and from side to side. Place the level along top edge and side edge

as shown (1).

2. If the unit is not level, rotate the adjustable leveling legs to raise or

lower each corner of the unit (2) as necessary.

3. To rotate rear leveler legs remove grille. See Removing and

Installing Grille.

4. Using the provided 6mm T bar allen wrench, rotate the 2

adjustment screws as shown below.

CAUTION

Do not use a power tool to rotate the two adjustment

screws. This can result in damage to the unit.

5. Check levelness after each adjustment and repeat the previous

steps until the unit is level.

Removing and Installing Grille

WARNING

• Disconnect electrical power to the unit before

removing the grille.

• Edges of sheet metal may be sharp.

Removing the grille.

1. Disconnect power to unit.

2. Using the included 7/64" Allen wrench, loosen, but do not remove

both grille lock screws. See below.

3. Gently pull grille away from unit until it stops.

4. Push grille rails towards the center of the unit to lift rails off lock

screws.

5. Pull grille free from unit.

Installing the grille.

1. Align slots in grille rail with screw heads in base of unit.

2. Push grille rails towards the center of the unit and set rails over

screw head.

3. Slide grille into position. Using included 7/64" Allen wrench, tighten

grille lock screws.

Adjusting Grille

The grille has an automatic vertical plane adjustment and can also be

adjusted on its horizontal plane as well. To adjust your grille to match

your surrounding cabinetry follow the instructions below.

1. Loosen, but do not remove, the lock screws on the inside of the

grille rails. Lock screws are located on the inside of each grille

rail.

2. Pull grille out to desired position and secure lock screws.

3. The grille skirt may be manually adjusted to the height of your

floor. Simply raise or lower the skirt as needed.

3000 Series Maintenance

Rotate Clockwise to raise rear leg.

Rotate Counter-Clockwise to lower leg.

Rotate Forward Feet to Adjust

Grille Mounting

Screws

Grille

Skirt

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17

Comments to this Manuals

No comments

U-Line U-3018CLRS-01 Troubleshooting Guide Page 11

Comments to this Manuals

Related products and manuals for Unknown U-Line U-3018CLRS-01