U-Line CLRCO2075 Installation Guide download pdf (Page 7)

02/2005 7 www.U-LineService.com

™

CLRCO2075 — Clear Ice Maker/Refrigerator

Side-By-Side Installation

Instructions

For a complete refreshment center, install your

CLRCO2075 Clear Ice Maker/Refrigerator beside a U-Line

Drawer or Wine Captain Model (see Figure 11 for typical

cut-out). Note that each Side-By-Side Installation will be

different.

• Cut-out width for a side-by-side installation is the total

of the widths listed under Cut-Out Dimensions in each

unit’s Installation Guide.

For example:

Placing a CLRCO2075 Clear Ice Maker/Refrigerator next

to a 2015 series unit would require a cut-out width of:

24-3/16" + 15-3/16" = 39-3/8"

Placing a CLRCO2075 Clear Ice Maker/Refrigerator next

to a 2075 series unit would require a cut-out width of:

24-3/16" + 24-3/16" = 48-3/8"

•

No trim kit is required. However, 1/4-inch space needs to

be maintained

between the units to ensure

unobstructed door swing.

• Units must operate from separate, properly grounded

electrical receptacles placed according to each unit’s

Electrical Specifications.

(Black and White Units Only)

Two types of custom door panels can be installed on your

Black or White unit to harmonize with or accent the

surrounding décor: a Custom 1/4" Insert or a Full Overlay.

If no custom door panel is used, go on to 5 Adjust Door.

Custom 1/4'' Door Panel Insert

Door Panel Preparation

A custom door panel can be inserted into the doorframe.

Custom door panels can be flat or raised, as long as the

maximum panel thickness where inserted into the door

reveal (channel) is 1/4"-thick. For raised panels, the depth

of the reveal is 1/4" on all four sides.

IMPORTANT

Raised panels will reduce the door’s 90° swing/zero

clearance if the unit is installed next to a wall or similar

type of structure (see Page 5).

Cut the panel insert to the following dimensions.

Custom 1/4" Dimensions:

Width: 23-1/32"

Height: 28-5/32"

The door panel must not weigh more than 20 lbs.

Door Panel Installation

Install the insert as follows:

1. Remove the door shelves by first pulling shelves

up at a 45° angle then straight out (see Figure 45 on

Page 18).

CAUTION

Use care when handling the insert. Insert edges may be

sharp.

2. Remove top hinge screw pin (7/64" Allen wrench or

Phillips screwdriver, depending on your unit’s

construction, see

Figure 12

). Remove door by tilting

forward and lifting off bottom hinge pin.

Preferred

Location for

CLRCO2075

Receptacle

Acceptable

Location

1-1/2"

24"

34-1/4"

35-1/8"

1/4" Space

Between

Appliances

Figure 11

Typical Side-By-Side Cut-Out

4 Prepare and Install Door Panel

1 2 3 4 5 6 7 8 9 10 11 12 ... 20 21

Comments to this Manuals

No comments

U-Line CLRCO2075 Installation Guide Page 7

Comments to this Manuals

Related products and manuals for Unknown U-Line CLRCO2075