U-Line U3024RFS00 Use and Care Guide download pdf (Page 14)

12 U-Line 3000 Series Maintenance

Adjusting Grille

The grille has an automatic vertical plane adjustment and can also

be adjusted on its horizontal plane as well. To adjust your grille to

match your surrounding cabinetry follow the instructions below.

1. Loosen, but do not remove, the lock screws on the inside of

the grille rails. Lock screws are located on the inside of each

grille rail.

2. Pull grille out to desired position and secure lock screws.

3. The grille skirt may be manually adjusted to the height of your

floor. Simply raise or lower the skirt as needed.

Adjusting Interior Shelves

Models equipped with glass shelves have an adjustable mounting

system. To adjust or simply remove shelves for cleaning, follow the

instructions below.

Removing / Installing Glass Shelves.

1. Remove all product from shelf.

2. Coming from underneath the shelf, lift both the front and rear of

the glass.

3. Carefully slide shelf out of unit being careful not to scratch the

interior liner.

4. Installation is the reverse of removal.

Adjusting shelf height.

Shelf height may be adjusted to accommodate a broad range of

product. To alter your shelf spacing follow the instructions below.

1. Remove the 4 Shelf clips from the shelf clip holes.

2. Move shelf clips as a group to the desired shelf height.

3. Insert shelf clips into the holes of the desired shelf height. Be

certain shelf clip is fully seated into shelf clip hole.

WARNING

Clips MUST be installed with the ribbed side down.

Failure to do so may result in shelf or unit damage.

IMPORTANTIMPORTANT

All 4 shelf clips for each shelf must be installed at the

same height for shelf stability.

4. Reinstall shelf.

Cleaning Shelves

Shelves may be cleaned in a soapy warm water solution. A general

household disinfectant may be used if necessary. Be sure to

completely dry your shelf before reinstalling.

Wine Rack Removal and Installation

Wine cabinets are equipped with full extension wine racks. To

remove your wine racks for cleaning follow the instructions below.

To remove a rack from the cabinet:

1. Remove any bottles stored on the rack.

2. Grasp the end of the rack, and gently slide it out until it stops.

3. The release lever are located on the inside of the rack rails.

Press the left rack release lever down. At the same time, lift the

matching right rack release lever up. Pull the rack out until it is

free of the tracks and the cabinet.

IMPORTANTIMPORTANT

Do not remove the track rails from the cabinet.

To insert a rack in the cabinet:

1. Align the left and right rack channels with the tracks in the

cabinet. Ensure an even track engagement on both sides by

gently pushing the rack into the cabinet until it stops.

2. Before reloading the rack, ensure proper movement of the

travel stops in the left and right track rails by pulling the rack out

gently until it stops.

Cleaning Wine Racks.

3. Saturate a soft cloth with a soapy, warm water, solution.

4. Wring excess water from cloth and wipe racks down.

IMPORTANTIMPORTANT

The wine racks are greased. This white lithium grease

helps provide smooth operation of the slide mechanism. It

is important not to remove grease.

Grille

Skirt

Clip Holes

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

U-Line U3024RFS00 Use and Care Guide Page 14

Comments to this Manuals

Related products and manuals for Drink coolers U-Line U3024RFS00